DuraLabel 9000 Betriebsanweisung PDF herunterladen (Seite 27)

A. Gap Mode

Press the or to move the cursor to the media type and press

to enter the sensor calibration mode.

Note: If printing from enclosed software/driver, the software/driver will send out

the GAP or BLINE command, which will overwrite the sensor type setting

set from the front panel.

A-1 Automatic

When you enter the [Automatic] option, you will see following message, and

the printer will feed 2 to 3 gap labels to calibrate the sensor sensitivity

automatically. When calibration is completed, the LCD screen will return to

the previous menu.

A-2 Manual

If “Automatic” sensor calibration is unable to adjust the supply, please use

“Manual” function to calibrate the gap sensor manually.

When you enter the [Manual] option, you will see following message. Please

complete these steps:

Paper Len.

00812 dot

1. Press to move the cursor

from left digit to right digit, and press

to set the value from “0” to “9”

and the “dot/ mm/ inch”. Press

to set the paper length into

the printer.

Calibration 1/4

> Gap Mode

Bline Mode

Cont. Mode

Gap Mode 1/4

> Automatic

Manual

Pre-Printed

Gap Mode

Automatic

Gap Mode 2/4

Automatic

> Manual

Pre-Printed

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 52 53

Keine Kommentare

DuraLabel 9000 Betriebsanweisung Seite 27